Differences

This shows you the differences between two versions of the page.

--- products:aircraft [2016/05/18 22:17]
Andreas Breitschopp
+++ products:aircraft [2017/08/29 12:42] (current)
Andreas Breitschopp ↷ Page moved from features:aircraft to products:aircraft
@@ Line 18: / Line 18: @@
 Here you can see the indicated and true airspeed of the aircraft.
-Additionally the mach speed is displayed as well.
+Additionally the ground and mach speed is displayed as well.
 ==== Altitude ====
@@ Line 24: / Line 24: @@
 {{https://www.fs-flightcontrol.com/img/manual/features/aircraft/status-altitude.png?nolink|}}
-In the altitude section the current aircraft altitude above mean sea level (MSL) as well as the altitude above ground level (AGL) is displayed.
+In the altitude section the current indicated altitude, the altitude above mean sea level (MSL) as well as the altitude above ground level (AGL) is displayed.
 Additionally you can see the barometric pressure and the local QNH.
@@ Line 46: / Line 46: @@
 Here you get an overview of the whole electrical system of the aircraft.
-You see the current load and voltage of all electrical bus system, see if the battery is currently charging or not and can trigger the APU if needed.
+You see the current load and voltage of all electrical bus system, see if the battery is currently charging or not and can trigger the APU or external/ground power if needed.
+:i: Note: Some options are only available if ProSim, AST or JeeHell is connected.
 ==== Pressurization System ====
@@ Line 55: / Line 57: @@
 You can also adjust the target cabin altitude and enable the dump switch.
+==== Exit Doors ====
+{{https://www.fs-flightcontrol.com/img/manual/features/aircraft/status-exit-doors.png?nolink|}}
+Here you can open and close again the exit doors of your aircraft.
 ===== Engines =====
@@ Line 77: / Line 85: @@
 There are quick access buttons for 0 %, 25 %, 75 % and 100 %, but you can also enter any specific percentage you want. Also reverse trust can be enabled for a specific or all engines by clicking on the button ''Reverse Trust'' if the engine supports that.
+:i: Note: The engine quick start options are only available if ProSim is connected.
 ==== Engine Switches ====
@@ Line 128: / Line 138: @@
 Here you can generate an aircraft that will trigger a TCAS alert.
-We want to highlight that the aircraft really is visible in the flight simulator.
+First choose the aircraft type that should be generated. By default this is the aircraft you are currently flying.
+Next you can define the location where the aircraft is being generated. You can either select one of the pre-defined location or enter a specific degree (in relation to the current aircraft heading).
+Now enter the distance to the generated aircraft and the true airspeed it will be flying towards you.
+You can also define a specific altitude (by default exactly the altitude your aircraft is currently at) and a vertical speed.
+Finally trigger the aircraft generation with the button ''Generate TCAS Aircraft'' and remove all previously generated aircraft with the button ''Remove all TCAS Aircraft'' again.
+===== ATC Control =====
+{{https://www.fs-flightcontrol.com/img/manual/features/aircraft/atc-control.png?nolink|}}
+Use these buttons to show or hide the ATC window and choose from the shown menu options.
-So be careful: After generation there is an aircraft flying towards you!
+:i: Note: If X-Plane is used you can only show or hide the ATC window here.

User Tools

Site Tools

Differences

Page Tools