User Tools

Site Tools


Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
features:aircraft [2020/03/21 17:22]
Andreas Breitschopp
features:aircraft [2023/01/17 10:41] (current)
Andreas Breitschopp
Line 11: Line 11:
  
 Some generic aircraft gauges are displayed on this page. Some generic aircraft gauges are displayed on this page.
- 
-You can click on each of those gauges to detach them into a separate window. 
  
 ==== Six Pack Gauges ==== ==== Six Pack Gauges ====
Line 25: Line 23:
  
 And here you see a generic Primary Flight Display (PFD). And here you see a generic Primary Flight Display (PFD).
 +
 +==== Detach ====
 +
 +{{https://​www.fs-flightcontrol.com/​img/​manual/​features/​aircraft/​gauges-detach.png?​nolink|}}
 +
 +You can click on each of those gauges to detach them into a separate window.
 +
 +Use the little pin icon in the title bar to keep the gauge window always on top.
  
 ===== Aircraft Status ===== ===== Aircraft Status =====
Line 30: Line 36:
 This aircraft status page will get you an overview about all relevant aircraft parameters. This aircraft status page will get you an overview about all relevant aircraft parameters.
  
-==== Airspeed ​====+==== Speed ====
  
-{{https://​www.fs-flightcontrol.com/​img/​manual/​features/​aircraft/​status-airspeed.png?​nolink|}}+{{https://​www.fs-flightcontrol.com/​img/​manual/​features/​aircraft/​status-speed.png?​nolink|}}
  
 Here you can see the indicated and true airspeed of the aircraft. Here you can see the indicated and true airspeed of the aircraft.
Line 68: Line 74:
 You see the current load and voltage of all electrical bus system, see if the battery is currently charging or not and can trigger the APU or external/​ground power if needed. You see the current load and voltage of all electrical bus system, see if the battery is currently charging or not and can trigger the APU or external/​ground power if needed.
  
-:i: Note: Some options are only available ​if ProSim, AST or JeeHell is connected.+:i: Note: Some options are only available ​with certain third party aircraft options enabled.
  
 ==== Pressurization System ==== ==== Pressurization System ====
Line 83: Line 89:
  
 Here you can open and close again the exit doors of your aircraft. Here you can open and close again the exit doors of your aircraft.
 +
 +==== Glider Towing ====
 +
 +{{https://​www.fs-flightcontrol.com/​img/​manual/​features/​aircraft/​status-glider-towing.png?​nolink|}}
 +
 +Control glider towing and release in this section.
 +
 +:i: Note: The winch option is only available with X-Plane.
  
 ===== Engines ===== ===== Engines =====
Line 106: Line 120:
 There are quick access buttons for 0 %, 25 %, 75 % and 100 %, but you can also enter any specific percentage you want. Also reverse trust can be enabled for a specific or all engines by clicking on the button ''​Reverse Trust''​ if the engine supports that. There are quick access buttons for 0 %, 25 %, 75 % and 100 %, but you can also enter any specific percentage you want. Also reverse trust can be enabled for a specific or all engines by clicking on the button ''​Reverse Trust''​ if the engine supports that.
  
-:i: Note: The engine quick start options are only available ​if ProSim is connected.+:i: Note: The engine quick start options are only available ​with certain third party aircraft options enabled.
  
 ==== Engine Switches ==== ==== Engine Switches ====
Line 152: Line 166:
 And use these buttons to control even more aircraft switches. And use these buttons to control even more aircraft switches.
  
-===== TCAS Alert =====+===== TCAS Traffic ​=====
  
-{{https://​www.fs-flightcontrol.com/​img/​manual/​features/​aircraft/​tcas-alert.png?​nolink|}}+{{https://​www.fs-flightcontrol.com/​img/​manual/​features/​aircraft/​tcas-traffic.png?​nolink|}}
  
 Here you can generate an aircraft that will trigger a TCAS alert. Here you can generate an aircraft that will trigger a TCAS alert.
Line 166: Line 180:
 You can also define a relative altitude (by default it is generated exactly at the altitude your aircraft is currently at) and a vertical speed. You can also define a relative altitude (by default it is generated exactly at the altitude your aircraft is currently at) and a vertical speed.
  
-Finally trigger the aircraft generation with the button ''​Generate ​TCAS Aircraft''​ and remove all previously generated aircraft with the button ''​Remove all TCAS Aircraft''​ again.+Finally trigger the aircraft generation with the button ''​Generate ​Intruder ​Aircraft''​ and remove all previously generated aircraft with the button ''​Remove all Intruder ​Aircraft''​ again
 + 
 +:i: Note: The intruder aircraft type and vertical speed cannot be set if X-Plane is used. Also only one intruder at the same time is supported for X-Plane.
  
 ===== ATC Control ===== ===== ATC Control =====
Line 176: Line 192:
 :i: Note: If X-Plane is used you can only show or hide the ATC window here. :i: Note: If X-Plane is used you can only show or hide the ATC window here.
  
-===== Custom =====+===== Change Aircraft ===== 
 + 
 +{{https://​www.fs-flightcontrol.com/​img/​manual/​features/​aircraft/​change.png?​nolink|}} 
 + 
 +To change your aircraft in the simulator first select the new aircraft from the list and then click on the button ''​Change Aircraft''​. 
 + 
 +With a commercial license you can restrict the aircraft available for selection in this dialog in the [[features:​settings#​change_aircraft|Settings]] module or disable this function altogether. 
 + 
 +:i: Note: The simulator does not provide a preview image for all aircraft. 
 + 
 +===== Custom ​Buttons ​=====
  
 {{https://​www.fs-flightcontrol.com/​img/​manual/​features/​aircraft/​custom.png?​nolink|}} {{https://​www.fs-flightcontrol.com/​img/​manual/​features/​aircraft/​custom.png?​nolink|}}
  
 This section will be available when you have created custom bottoms in the [[features:​settings#​custom_buttons|Settings]] module. This section will be available when you have created custom bottoms in the [[features:​settings#​custom_buttons|Settings]] module.
 +
 +The buttons shown above are the result of the [[features:​settings#​examples_and_reference|examples here]].